2gig PANIC1 Single Wireless Panic/Medical Emergency Button Remote

The 2GIG-PANIC1 Panic Button Remote was designed to transmit an emergency signal from any location within the range of the 2GIG Alarm System. Signals from the button will be transmitted whether the system is armed or disarmed.

The button is small and lightweight enough to be placed in a shirt pocket or tucked away inside a purse. it can also be used with the supplied wristband, lanyard, car-visor clip, or belt clip. It can also be permanently mounted to a convenient location.

To activate, press and hold the button for approximately 2 seconds. The LED located on the top of the unit will light up for approximately 2 second to confirm a signal has been sent.

Specifications:
Wireless Signal Range: 350 ft., open air, with 2GIG V/ireless Alarm Control Panel
Code Outputs: Alarm; Supervisory; Low Battery
Transmitter Frequency: 345.000 MHz (crystal controllad)
Transmitter Frequency Tolerance: ± 15 kHz
Transmitter Bandwidth: 24kHz
Modulation Type: Amplitude Shift Keying-On/Off Keying (ASK-OOK)
Unique ID Codes: Over one 1 x million different code combinations
Supervisory Interval: 70 minutes
Peak Field Strength: Typical 36,000 uV/m at 3m
LED: Red (when activated)
Dimensions (LxWxH): 1.65 x 1.20 x 0.50 in. (4.19 x 3.05 x 1.27 cm)
Weight (including battery): 0.45 02. (12.8 g)
Housing Material: ABS plastic
Color: White with grey button
Operating Temperature: 32° to 120°F (0° to 49°C)
Relative Humidity: Water resistant
Battery (included, not installed): One 1 x Panasonic CR2032, or equivalent Lithium battery

Whats's Included:
1 x Lanyard
1 x Wristband
1 x Wall mount
1 x Belt clip
1 x Car-visor clip