Xantech 78944 1-Zone / 4-Source IR Infrared Connecting Block, Four Way Signal Spliter
The Model 789-44 provides a quick low cost means of connecting Xantech IR receivers and keypads to four single or four dual emitters, with a power supply, in an infrared repeater system. It can also provide emitter expansion for various Xantech devices, such as the 590, 710, 792-10, 795-20, 796-20, etc.. The STATUS terminal provides a convenient tie point for voltage to drive the STATUS indicator on certain Xantech products, such as the 780- 80 IR Receiver
Specifications:
 Inputs: 1 - Screw type 4-terminal plug-in. 1 - IR Receiver "IR RCVR" 3.5mm stereo mini jack.
 Outputs: 4 - Emitter ports (3.5mm mono mini jacks) parallel driven.
 Contains a 470 Ohm resistor in series with each emitter output.
 Xantech 282, 283, 284 & 286 Mini Emitters may be used.
 Power requirements: 12 volts DC. Uses 781RG or 782-00 Power Supplies. Note: A power supply is not connected to the 789-44 when it is used as an emitter expander.
 2.1 mm coaxial power jack.
 Dimensions: 2-15/16" W x 1-3/4" D x 13/16" H
Mounting:
The 789-44 can be conveniently mounted to a wall or shelf by using the two sheet-metal screws supplied. The unit may be mounted in any orientation to accommodate the installation.
Specifications:
 Inputs: 1 - Screw type 4-terminal plug-in. 1 - IR Receiver "IR RCVR" 3.5mm stereo mini jack.
 Outputs: 4 - Emitter ports (3.5mm mono mini jacks) parallel driven.
 Contains a 470 Ohm resistor in series with each emitter output.
 Xantech 282, 283, 284 & 286 Mini Emitters may be used.
 Power requirements: 12 volts DC. Uses 781RG or 782-00 Power Supplies. Note: A power supply is not connected to the 789-44 when it is used as an emitter expander.
 2.1 mm coaxial power jack.
 Dimensions: 2-15/16" W x 1-3/4" D x 13/16" H
Mounting:
The 789-44 can be conveniently mounted to a wall or shelf by using the two sheet-metal screws supplied. The unit may be mounted in any orientation to accommodate the installation.