Cable Electronics SW204HD 4 x 2 Component HDTV Matrix Switcher

The SW204HD is a 4×2 Component HDTV Matrix Switcher, with Digital & Left/Right Audio and full Matrix capabilities, that allows the user to connect four HD sources to either of the two outputs, without having to swap cables. High bandwidth and low crosstalk provides maximum picture performance.

Specifications

Video
• Nominal Input level: 1 Volt peak to peak
• Gain: 1 Volt into 75 ohms (2 Volts Unterminated)
• Input Impedance: 75 ohms
• Output Impedance: 75 ohms
• Isolation port to port: >40 dB
• Isolation on to off: >60 dB
• Return loss: >18 dB
• Video bandwidth: > 100 MHz (HDTV requires 37MHz min.)

Audio

Analog:
• Nominal Input level: 1 Volt peak to peak
• Gain: Unity (one to one)
• Input impedance: 22k ohm
• Output impedance: 100 ohm
• THD: 0.05%
• Frequency Response: 20Hz to 100kHz
• Channel Separation: >75dB
• Port to Port Isolation: >50dB
• Out to Input Isolation: 60dB
• Signal to Noise: 80dB @ 2 Volts out

Digital:
• Supports Standard SPDIF digital audio.
• Unity gain when terminated into 75 ohms (2X gain into high impedance).
• Greater than 75 MHz of bandwidth to ensure minimal degradation.
• (If not used for digital audio, this port can be use to switch standard composite video.)

Power:
• Requirement: External 120 Vac input, 9 or 10 Volt AC output
• @ 1000mA with a 2.1mm coaxial connector.

What's Included
• 1 Power Supply
• 2 Rack Mount Ears
• 1 Application CD
• 1 IR Remote Control
• 1 Manual